• info@frolicpaints.com
  • +91-9717599332, +91-9205272763

FROLIC SRS

FROLIC SRS is a synthetic rubber-based adhesive specially designed for multipurpose applications. It exhibits excellent bonding strength. The adhesive dries to a tough, flexible film with good resistance to water and aging. This adhesive can be applied by brush, applicator/finger.

Key Features

  • Benzene free - Non-hazardous to health.
  • Exhibits excellent strength.
  • Preferred by the users dealing only in quality works.
  • Mild smell
  • Economical

Typical Application

FROLIC SRS is used to bond variety of substrates in:

  • PVC to mosaic/concrete substrate in flooring segment.
  • U-foam/Rubber foam to U-foam.
  • Rexine/leather to foam.
  • Wood/plywood to U-foam.
  • Coir to U-foam in upholstery segment.
  • Various handicraft application.
  • Car/bus body tops/roofs and Motorcycle/scooter seat cover pasting.
  • Veneer industry.
  • Footwear industry.

Typical Physical properties

Property Value
Appearance Brown liquid
Solid (% NVC, at 105°C/3 hrs) 37±1
Viscosity (by B4 cup) 10-15 poise
Diluent Toluene
pH 4-6
Flash point 0˚c to 4˚c
Drying time 20-40 sec approx.
Specific gravity at 30˚c 0.80-.85
Tack Retention time 45 minutes

Application guidelines

  • Clean the surface properly which is to be bonded.
  • Stir the adhesive before application.
  • Apply SRS on both surfaces.
  • Apply first on the Non-porous surface then on porous surface.
  • As soon as adhesive becomes dry, press both surfaces together.
  • Ensure uniform contact.
  • Final bond is achieved in 24 hours.

Clean-up guidelines

Drain the adhesive from the cylinder, pan, and reservoir into the container and if required, dispose as per local, state and federal regulation. Do not allow machine wet parts to dry out, immediately rinse with tap water to remove the bulk of the adhesive residue followed by further cleaning with IPA/Ethyl Acetate or other suitable solvent to remove any further residue.

Safety, handling and storage

  • Store in cool, dry, well ventilated area.
  • Protect from freezing.
  • Container once opened must be closed tightly to prevent contamination.
  • Do not mix other products without consulting technical team.
  • Stocks should be used on a first in first out basis.
  • Wash thoroughly after handling.
  • Wash contaminated goggles, face shield and gloves.
  • Do not reuse empty container without professional cleaning.

Disclaimer:

The data, information and suggestion contained in this literature are given purely as a recommended guide, based on our study and experience. It is recommended that prospective users verify the sustainability of the product for their intended application to their satisfaction.

Packaging:

  • 100
    ml

  • 200
    ml

  • 1
    L

  • 5
    L